HUATEC non destructive test equipment Metal mirror surface and coating surface gloss meter
HGM-B60MS metal small-pass gloss meter is a high-precision and miniaturized gloss meter manufactured in accordance with the standards of ISO-2813, ISO7668 and GB9754. It is suitable for the measurement of the mirror gloss value of coating or metal surface and other small measuring surfaces (such as polished metal decorative parts).
2.Application
●All kinds of paint coating and finishing surfaces, such as paints, varnishes, printing ink, etc.
●Suitable for metal mirror gloss measurement.
Technical parameter
3. The technical parameters up to JJG 696 (First-level standard).
- Display range of:0-2000 (Ｇs)
- Display error:0-199<2 Gu,120-1000<1% Gu
- Stability:<2Gu/30min
- measurement spot:14×28(mm)
- dimension:114×35×65 (mm)
- power supply:1.5V
- Measuring window size :1.5mm short axis ×3mm long axis (ellipse)
4. Calibration:
When the standard equipment on board and show that numerical standards board is greater than the difference between the nominal value of 1.2 gloss units, the following methods should be calibrated.
Measuring instruments on the window and down the board, press the "home / home zero" key, show value for the 0.0 at this time.
A black glass plate instead of the standard black-velvet panels, measuring instruments on the window, rather than pressing the "calibration / measurement of" key, set to enter the state, showed that at this time, "000.0" and the first "0" flashes. Rather than pressing the "shift" key-flashing shifted to right, rather than pressing the "home / home zero" key "flicker" values change from 0-9-0, through pressed "shift" and "home / home zero" Made with numerical keys and display glass panels with a nominal value of the same standard, at this time rather than pressing the "calibration / measurement," the completion of key settings. Then white ceramic standard equipment on board, show value and the standard white ceramic plate with a nominal value of the error should not be greater than ± 1.2 gloss units, or else should be considered standard dirty plates. After the completion of the above-mentioned steps can be measured samples.
Standard Delivery
| Gloss meter | 1pc |
| Instrument case | 1pc |
| Standard board | 2pc A black board is used for the highlight calibration A white board is used for the low light calibration |
| English instruction manual | 1pc |
| Calibration certificate | 1pc |
HUATEC Gloss meter Reference angle for different application
| angle | Point of reference for (foreign) (China) | Application |
| 20° | DIN-67530 ISO-2813 GB9754 ASTM-D523 ASTM-D2457 GB8807 | high gloss paint, ink, plastic. |
| 20° | ASTM-D1834 TAPPI-T653 GB8941.1 | high gloss stencil, cast coated paper. |
| 45° | ISO-2767 GB8941-2 | surface of aluminum and aluminum oxide. |
| 45° | ASTM-C346 GB/T3295 ASTM-D2457 GB8807 | pottery, ceramic, plastic, plastic film, Stone |
| 45° | JIS-E8741 | pottery, ceramic, plastic, plastic film, Stone |
| 60° | ISO-2813 GB9754 ASTM-C584 GB9966 ASTM-D523 DIN-67530 ASTM-D2457 GB8807 | Mid-gloss paint, ink, plastics, ceramics, stone. |
| 75° | ISO-8254 TAPPI-T480 GB8941.3 | copperplate paper |
